Anyone Running the CBI Dakar Hybrid Bumper?

Perry Parts V3 Bump Stops - I am fully sold

TrailJustin · 2026-02-04T15:35:04+00:00

I had the opportunity to be one of the early testers for the new bump stops from Perry Parts. There’s a lot that makes these bump stops different, and I want to be clear up front: these are not the same bump stops currently listed on the website. The new gen is a whole new design altogether. First thing you notice is size. These bump stops are much larger, they’re tuneable, and they’re designed to expand with your build over time instead of being something you replace later. The biggest design change is how they’re built. There’s a base section, and then the attachable bump stop itself. The base stays the same, while the bump stop can be changed out for a larger version, different materials, and more options in the future. The idea is that the bump stop grows with your build instead of being an afterthought. For example, if you start with a 3-inch lift and later move to a 6-inch lift, you won’t need to redo everything. You’ll just be able to screw on a different bump stop and keep moving forward. The design of the bump stop itself is honestly pretty genius. By using 3D printing, they’re able to build internal air channels and chambers that you just can’t easily do with injection molding. It’s not just about the material compressing—the bump stop is actually moving air in and out, which adds another level of tunability when it comes to controlling suspension travel. To top it all off, the packaging, instructions, and overall experience were just nice. You can tell this is an American-made company that actually cares. A lot of parts show up thrown in a box with a packing slip and maybe a sticker. These didn’t feel like that. It felt like someone actually took pride in what they were sending out. I’ll share more once I get some more time on them, but so far I’m pretty stoked on the direction Perry Parts is going with these.

TU3_Offroad

New member

Aug 19, 2025

I’ve been checking out the CBI Dakar bumper for the 3rd Gen Tundra and honestly it looks killer. Totally changes the front end and I like that it’s lighter than a full plate but still winch compatible. Being able to run a 30 inch light bar plus pods is a big draw too, and the improved approach angle is hard to ignore.

What’s holding me up is the install. Looks like there’s a good amount of trimming involved, but I think the pros outweigh the cons.

For anyone running it, how was install, did the sensors still work right after, and does the bumper feel as solid as it looks?

I’m really tempted, just want to know if it’s worth cutting up the stock bumper.

Anyone Running the CBI Dakar Hybrid Bumper?

TU3_Offroad

New member

Recent

Perry Parts V3 Bump Stops - I am fully sold

Napa, CA Wine Country Looks Good On The Tundra

Make your JBL System Louder

Lower knuckles look bad!

SXTH Element Off Road Trail Pipe for 3rd Gen Tundra

Shiftpower USA Tundra Throttle Enhancer

3D Printed Window Switch Button Cover

How to stop your V35A-FTS Tundra Motor from Failing

Swapping Out The 8in Screen for the OEM Toyota 14in Screen

Best Mod So Far: Upgrading to the 14”

Hello 3rd Gen Tundra Owners - Ironman 4x4 Here

Rear Recovery Points from SXTH Element

Similar threads