3D Printed Cup Holder Stabilizer

[TrailJustin]

This is a new things where I am taking 3D prints from the internet for the Tundra and testing them out to see if they are any good.

Link: https://www.thingiverse.com/thing:6010444/files

So is it any good? Yes the fit is snug and it stops things from falling over. Personally I did not have this problem to start with but my wife was grateful for them and her Stanley cup. I guess the larger Stanley cups like to fall over.

There is a file for both the front and rear cup holders and I used the following printer settings.

Filament: PETG
Walls: 4
Infill: 10%
Layer Height: .2